|
Environmental Measurements Limited |
|
A range of naturally aspirated sensor shields. |
Product Summary |
|
These Sensor Shields are produced using modern injection moulding techniques with stabilised plastic. Designed for the easy mounting of probes and sensors, they are fitted with a silicon seal to eliminate water-trap possibilities. The designs are of a multi-plate construction; the plate profiles are shaped to allow the minimum restriction of airflow while providing the necessary shielding from solar radiation and precipitation. The sensor is mounted through the lower plates and secured by the gland clamp. The top plates provide extra protection against temperature rise from direct solar. The shields are supplied complete with mounting bracket and clamps and will fit to vertical or horizontal masts up to 2" in diameter. At present five sizes of shield are offered. The SS1, SS3 and SS4 use the clamp style mounting. The SS5 and SS6 are suitable for our range of temperature probes. |
|
ORDERING INFORMATION: ORDER CODE SS1 SS3 SS4 SS5 SS6 Overall height 22 cm 16 cm 29.5 cm 14 cm 22 cm Diameter 12 cm 12 cm 12 cm 12 cm 12 cm Plate spacing 11 mm 11 mm 11 mm 11 mm 11 mm Top Plates 3 3 3 3 3 Lower Plates 10 5 15 5 10 Mount type Clamp Clamp Clamp Clamp Clamp Probe Max. Diameter 25.4 mm 25.4 mm 25.4 mm 6.5 mm 6.5 mm Probe Min. Diameter 18 mm 18 mm 18 mm 3 mm 3 mm
Note: All shields may be ordered without the bracket if this is preferred. To do this simply add the following /NB to the ORDER CODE from the above table. |
|
The SS1 - Naturally aspirated sensor shield |
|
To contact us: |
